-
INPUT: 100-240 AC; OUTPUT 7.2V ~ 12V 0.9A or 1.8A
-
Universal Smart Charger for any 7.2V ~ 12V NiMH battery packs.
-
Automatic Battery Voltage Detection.
-
Automatic Negative Delta V Cut-off when the battery gets fully charged.
-
Red LED will be on during charging. When battery is fully charged, current will reduce to trickle charging at 50mA, Green LED will be on.
-
One standard Tamiya male connector installed with the charger. Ideal for charging all 7.2V, 8.4V,9.6V and 12V RC Car, RC air and Airsoft (you need special cable for the Airsoft battery charging, please contact us for that cable) battery packs
-
One set of Clip adapter with female tamiya connector included for charging any battery packs.
-
One connctor adpator from standard Female Tamiya to Male Mini. Tamiya for charging RC air battery packs.
-
This smart charger is almost care-free. Just plug in and wait for battery charging ready
-
Battery will be charged at 0.9A or 1.8A constant current (selected by a switch)
-
Approx. Charging time is about 1.5hrs for 3000mAh battery; 1hr for 1800~2000mAh battery; for 1100 mAh, charging time is about 30 min.
-
The charger is designed for faster charging NiMH battery packs from 7.2V to 12V for RC car/Air and Air soft gun (you need special cable for the Airsoft battery charging, please contact us for that cable). 2000mA constant output current for any voltage battery pack.
-
Make sure battery polarity is connected correctly (Red wire is positive)
-
Maximum timer control for overcharge protection.
-
Protection fuse for over current, short circuit & reverse polarity.
-
This charger can not charge 12V higher battery. Can not charge Low drain current battery. Please don't use the charger for battery packs with capacity less than 1100mAh.
-
This charger is designed for indoor use only.
-
The Charger should be horizontally positioned and work in well ventilated condition, avoid wet and keep it away from inflammable explosive goods.
-
Don't cover the charger when charging, ambient temperature shall not be more than 40 centigrade degree.
-
Don't touch the plug.
-
Cut off the power supply before connect or disconnect the charger with batteries.
-
Don't try to disassemble the charger, High voltage inside,danger!