INCLUDES ALL NECESSARY WIRES TO HOOK UP TO ANY OF YOUR CARS!

PAGER / REMOTE TRANSCEIVER: The hand-held remote transceiver is used to send commands to and receive information from the 2009 FM Alarm system. The remote has a built-in clock timer so that you can program the remote to start your vehicle at any time. The Control Module transmits High Frequency FM signals to the pager for various alarm functions up to 1 mile away. Range will vary depending on location, terrain, and RF noise interference. This system is not guaranteed to page you if you are behind concrete walls underground, in a large structure, or an area with high electronic interference. Handle pager/remote with care as the LCD display and/or the electronics may be damaged if abused. Some icons and areas of the LCD panel are not used or do not animate. These areas are for future improvements and expansions of this system. Pull up the built-in antenna on the top left of the unit when additional range is required. Push the antenna PAGE/ in for storage in a pocket or purse. The transceiver uses a standard AAA Alkaline Cell battery that can easily be replaced by removing the access cover on the back of the unit. Battery life will vary depending on usage. (4-5 months on average). EMERGENCY OVERRIDE: If you have lost the transmitter or it stops working for any reason and the Alarm is armed, you will have to perform an emergency override to disarm the system. Open the door with the key, (alarm will sound) turn the Ignition ON and press and hold the overide/program button about 3 seconds. The Alarm will disarm, and enter the Valet mode to allow you to use the vehicle. You can repair/replace the pager/remote or see your installing dealer for assistance. TRUNK POP/AUXILIARY FEATURE: (Optional) To pop the trunk or activate an auxiliary feature, press button (III) on the transmitter for about I 1/2 seconds until it beeps. Trunk pop feature is recommended for vehicles equipped with a Factory Electric trunk release. Extra parts and/or labor may be necessary for this feature. If the system is armed, pressing button (III) may or may not trigger the alarm system when opening the trunk depending on programming option #10 configuration REMOTE ENGINE STOP: To stop (abort) a remote start, Press and hold Button (II) on the transceiver for about 1 1/2, seconds until it beeps. The alarm will acknowledge the abort remote start request by transmitting back to the Transceiver with (2) sets of 3 beeps. The LCD Display will show a Key with slash and the Engine Run icon will flash (2) times and turn off. The will remain armed if it was armed before the remote start took place. If the vehicle was not armed, it will remain locked after the remote start abort. ARMING: Press the (1) button on the transceiver to arm the system. The LCD Display will show "ARM" and "LOCK" icons while emitting a single beep. At the vehicle the siren will chirp once and the lights will flash once. The red LED in the vehicle will start flashing. The system will arm, lock the doors, and the starter will be disabled (Optional). VALET MODE: To disable the Alarm and Remote Start sections of the system while still allowing door lock/unlock, turn the igntion ON and press the override/program button until the dash LED turns on solid and one siren chirp is heard (about 5 seconds). Repeat the process to exit valet mode (LED will turn off, lights flash twice, and chirps twice). REMOTE ENGINE START: Press and hold Button (II) on the transceiver for about 1 1/2, seconds until it beeps The alarm will acknowledge the remote start request by transmitting back to the Transceiver with 3 beeps and the Key/Engine Run icons on the LCD Display. At the vehicle, the unit will chirp (3) times and the parking lights will turn on solid. After powering up the Ignition and Accessory circuits, the unit will start the vehicle and run for 15 or 25 minutes (whichever is programmed). Once the vehicle is running (in the first 8 seconds) the control module will page the remote with engine run status (LCD display will show a spinning engine run and exhaust). If the vehicle fails to start on the first attempt, the system will try (2) more times before aborting the remote start process. ENTERING A REMOTE STARTED VEHICLE: To enter a remote started vehicle, press bunon (1) to Unlock/Disarm, insert key and turn on to the run position [DO NOT Turn the key to the Start position or you damage the Starter!], tap on the foot brake to reset the unit and drive away as normal. The key is now operating the vehicle. The optional ANTI-GRIND feature and can help to avoid starter damage from turning the key over and re-engaging the starter on a nunning engine DEFECTIVE ZONE ALERT/BYPASS: If the system detects a faulty or open zone (Door left open) when the system is ACTIVELY ARMED, the siren will chirp (3) times, give (3) light flashes, and the control module will page the remote with the open zone (Door or Trunk) The faulty zone will be automaticallv bypassed. AUTOLOCK/UNLOCK WITH IGNITION: (Programmable) The doors will automatically lock when the ignition is turned on and will unlock when the ignition is turned off. If a door is open the unit will not lock to prevent keys from being locked in. PASSIVE ARMING / PASSIVE LOCK MODES: If programmed for passive (Automatic) Arming, the system will Arm itself 30 Seconds after the ignition is turned off and the last door has been closed. The LED will begin flashing rapidly while counting down to Passively Arm. If a door is open or reopened during the countdown the system will wait (LED solid) for the door or zone to close before arming. The unit will chirp once and flash the lights once. If Passive Locks are programmed ON then doors will lock also. Note: Passive Arming may qualify for insurance discounts-check with your agent or proprietor. Passive locking may increase the chance of locking the keys inside the vehicle. DISARMING: Press the (1) button on the transceiver. The LCD Display will show "DISARM" and "UNLOCK" icons while emitting (2) beeps. At the vehicle, the siren will chirp (2) times and the lights will flash (2) times. The red LED in the vehicle will turn off. The system will disarm unlock the doors, and the interior dome light will turn on if these optional featrures are installed. SILENT ARM/DISARM: (Programmable) The system can programmed to ARM and DISARM silently without Siren Chirps. See programming