6.6ft (2m) Advertising Coffee Mug Cup Balloon PVC

 

if you own a coffee store, this is certainly a good way to advertise your business by placing it in front ot your store, roof of your store or even hang it above the door. imagine that people flock to take pictures with it and your store becomes the talk of town!

 

this is a custom made listing; lead time about 4 days and shipping about 5 days; the one in picture was purchased by a customer in California;   

 

one mug shaped PVC balloon; 6.6ft (2m) high; weight about 16 lbs;

printing of your logo on both sides of the mug is free (fading effects excluded);

 

balloon has attachment points for tie-downs as well as set-up for internal lighting at night time (you just need to have the cable and the bulb; bulb is prohibited item in shipping; notice that the bulb/light must NOT be the heat-producing household bulbs, otherwise the balloon will be burned);

 

shipping rate quoted is for U.S., Canada, Western Europe and Australia/New Zealand; other buyers need to confirm shipping rate first; all buyers MUST provide valid shipping address (no PO box); PayPal, bank transfer and most other payments are accepted;

New Jersey residents need to pay 7% tax;

 

1)  place a tarpaulin, about 5 sq yard, on the ground and gently spread out the pvc balloon (mug); locate the inflation tube or sleeve;

2)    use an air compressor or other small blower for inflation (avoid using big blowers!); while inflating gently and slowly help spread out the balloon; this is necessary because, unlike most other pvc balloons, there are four layers of pvc sheet and pulling lines inside and they could be damaged otherwise; as a rule of thumb, 90% full is good;

3)    along the inner side of the mug handle are two small holes; please use transparent tape to seal one and inflate the other till the outer layer of balloon is almost full and pretty; then seal the hole with tape too;

4)    once inflation is completed, please lay the balloon on its side and pull out the rope from the top of the mug and tie up the light bulb there; the wire shall go through the hole and it is to be secured at the mug handle; this way the mug will look pretty;

5)    now proceed to turn the mug on its bottom and adjust the positions; use the tie-down ropes and sand bags to secure the mug.

 

Qestions? inflatable4less@gmail.com