Airsoft Active braking mosfet includes 2 pair deans

These are Active Braking Mosfets based on the AB-SW mosfet from Extreme Fire.
Terry helped me design these with the best mosfet units we could find.

Im making these as a hobby so wont be making loads and loads.

These mosfets come with the following:

• 1x AB mosfet unit
• 2x Dean connectors with heatshrink
• 1m high grade thin walled 1mm2 battery positive
• 1m high grade thin walled 1mm2 battery negative
• 1m high grade thin walled 1mm2 motor positive
  
• 1m high grade thin walled 1mm2 motor negative
• 1m trigger wire.
  

Dimensions:

 

28mm x 22mm x 17mm

1.1inch x 0.87 inch x 0.67 inches

 

Specification:

 

Max continuous amp draw = 70A

Max Peak Current draw = 260A

Max voltage = 30V

 

Benefits:

1. Full active braking that is gentle enough not to harm the motor but still stops the motor very quickly.

2. Fully assembled, production tested.

3. The Mosfets are fully protected against voltage spikes from the motor.

4. It is almost impossible to cross conduct the Mosfets.

5. Fully protected against static discharge.

6. Resistant to damp and condensation.

7. The circuit draws no current when not triggered.

8. The trigger circuit needs considerable current to turn on preventing false firing from condensation, grease, etc.

9. Made compact to minimize size needed for installation.

10. High grade thin walled insulation 1mm2 wires installed.

11. Failure of the active breaking MOSFET can't turn the gun uncontrollably on

I have positive feedback on these units.