CNC STEPPER SERVO MOTOR STEP Pulse Generator & TESTER

NEW PRODUCT--NEW PRODUCT--NEW PRODUCT. Run your motors without a computer

<<-See 250 more great CNC items in our ebay CNC store by clicking store home or a catagory on the left.

This is a must have device for those of you in CNC.  This is a handy little STEP and DIRECTION signal Generator 1-3/4"w. X 3"l. X 7/8"t.  It is easy to use, with screw lugs to your step and direction outputs  and your signal ground inputs on your driver board.  Turn the on switch on and the motor will turn if your driver is working.  It has a reversing switch, and two pots to tune the step pulse width and the step pulse rate.  This is what we use on our Work-bench to test stepper and servo motor driver setups to see if they work, And it can be used stand-alone without a computer  to run various motor driver systems.  Hook it up, turn it on and spin your motors foreward or reverse, fast or slow, long or short, simply by turning the pulse frequency output pot, or using the direction switch, or the on and off switch, all handily located on the top side of the board for easy use and access. Comes complete with manual, and Schematic.

This is NOT a stepper motor Driver, it is a step signal generator to send step pulse signals and direction signals to your stepper or servo motor driver (servo drivers that accept step and dir.), to either run them outright, or to verify that your drivers work and will run motors.

It comes with the power supply, Since there are screw lug connections, we no longer ship with allagator clips shown in the pictures.

Should be $59, but for a short period of time we are introducing it at $29.99.

try it you'll like it, small investment for all of the good that it does for you.

COMBINED SHIPPING SAVINGS ---HOW TO GET IT---SEE *** BELOW

***  combined shipping here is how to get it.

1. Buy the items in ebay don’t pay yet.
2. go to items “WON” link in ebay
3. find one of your items in the list, and click the drop down menu to the right.
4. find the “request total” item in the menu and click.

That’s all you need to do. DON”T do it on a single item purchase, JUST PAY IT, but if you do it will give us the opportunity to add paypal insurance to your invoice. If you follow the above procedure, please do not send me an additional email requesting a total, that is already done in the procedure

See a video of this item in action plus a short visit to our ebay CNC store

To Watch a short video of our new CNC item and a sample of what's in our ebay CNC store.                                           Click Here--> http://www.youtube.com/v/cVpuQwudbrg

<<-Enter our ebay CNC store by clicking store home on the left or a catagory.