Intermatic Time Clock Timer Motor WG1573-5 / WG1573-10D

New

INTERMATIC TIME CLOCK MOTOR

Original Intermatic Factory Replacement Part for 220 Volt Timers

Manufacture Model #:  WG1573-10D

Part #:  WG1573-5

208/277V 60Hz  3W

 New original replacement timer motor for the Intermatic time-clock mechanism.

Get your your equipment back on a regular automatic cycle again without the hassle of turning it ON & OFF manually again.

Why spend big bucks for a brand new time clock mechanism. Get it repaired by simply switching out the clock motor. Usually 99% of the time the reason for a non-moving clock dial is due to a bad timer motor. 

Manual Check: If you notice that clock dial does not move automatically or keep the correct time of the day and if your able to turn your equipment on with the manual on/off swich lever switch, then you most likely have a bad timer motor and it will need to be replaced.

Visual Check: Power must be on to perform the following check. Carefully look through the oval visual check window located on the right side of the mechanism and check to see if the gears are turning. If the black gears on the clock motor are Not moving, then the clock motor is bad and will need replacing.

Clock motor # WG1573

 Timer motor is located on the back side of clock mech.

Caution: Practice safety! Always turn off the power at the circuit breaker of the device being repaired. Never attempt to install this or any other electrical device with the power on! Buyer assumes all responsability and risk on the repair and installation of this product device. If in doubt, contact a qualified  licenced electrician.