Kicker SX700.4 175wrms x 4 w/Digital Display Controls!

Features:

* Low Impedance Operation: Stable into 2 Ohm Stereo or 4 Ohm Mono Loads

* SORT Protection Circuitry: (Short Circuit, Over-Voltage, Reverse Polarity, Thermal) Protects Amplifier from Accidents and Undesired Operation

* MOSFET Power Supply

* KickBass: Variable Bass Boost Circuit Which Provides up to 18dB of Boost at 40Hz

* PAST (Pre Amp Signal Transfer): Output RCA Jacks to Pass the Incoming Signal to Another Amplifier or Component

* SAMS (Stereo And Mono Simultaneously): Amplifier will Operate into a Bridged Mono Load and a Stereo Load at the Same Time

* Low Pass Filter - Fully adjustable digital crossover with variable slope and crossover frequency. 30Hz to 20,000Hz in 1/12 octave spacing. OFF-36dB per octave slope in 6dB increments.

* High Pass Filter - Fully adjustable digital crossover with variable slope and crossover frequency. 10Hz to 16,000Hz in 1/12 octave spacing. OFF-36dB per octave slope in 6dB increments.

* KickEQ: Fully adjustable single band digital parametric equalizer with variable Q (bandwidth), variable center frequency and variable boost or cut. Q range .5 to 10 in .5 steps. Center frequency 20Hz to 20,000Hz in 1/12 octave steps. Boost or Cut range +/-18dB.

* Adjustable Phase: The output phase of each channel can be set at 0 degrees or 180 degrees. Left and Right channels can be linked or independantly adjusted.

* UltraMatch Gain Structure: Digital input gain control with 5 selectable gain ranges (1 Volt, 2 Volt, 4 Volt, 8 Volt, 16 Volt) with 12dB of adjustment in each range in .5dB steps. Left and Right channels can be linked or adjusted independantly.

* Sickbay and On Board Diagnostics: Various tools to troubleshoot installation issues and check amp status.

* Kompressor: A 4 setting, user-selectable bass compressor used to fatten up your sub bass. OFF, TIGHT, CONTOUR, and ATTACK with +/- 24dB of adjustment to compensate for speaker size and listening style.

* ISIS: (Indicate Status & Input Settings) The user interface to view or adjust current settings and check the status of your Kicker SX amplifier.

* BLAST (Bass Level And Signal Transfer): Provides remote bass level control and control signal transfer between multiple SX amplifiers.

* Power Output:  82W RMS x 4 Channel @ 4 Ohms (0.02% THD)

OR

* Power Output: 163W RMS x 4 Channel @ 2 Ohms (0.2% THD)

OR

* Power Output: 325W RMS X 2 Channel (Bridged Mono) @ 4 Ohms (0.4% THD) 

* Signal to Noise Ratio: >100dB

* Frequency Response: 20Hz to 20000Hz (+0 / -1dB)

* Variable KickBass Boost: 0 to +18dB Boost @ 40Hz

* Power and Ground Terminals will accept wire up to 2 Gauge