All-in-one wire welding package welds 24 gauge - 5/16 in (0.8 - 7.9 mm) mild steel.
New! More output.Capable of welding up to 5/16 inch mild steel in a single pass.
New! Smooth-Start patent-pending technology provides a smooth, spatter-free start. The best starting machine in the small MIG category. No more pop-gun starts or spatter to clean up.
Infinite voltage control with Manual On/Off wire feed speed tracking provides a broader operating range with finer control by automatically increasing or decreasing wire feed speed when voltage is adjusted (unit shipped with wire feed speed tracking set to "off").
Durable cast aluminum feedhead incorporates dual groove quick-change drive roll and spring-loaded tension arm with calibrated tension knob all designed to make setup easier and faster.
Thermal overload protection shuts down the unit and activates over temperature light if airflow is blocked or duty cycle is exceeded. Automatically resets when fault is corrected and unit cools.
Miller's exclusive "Tip Saver" short circuit protection shuts down output when tip is shorted to the work. Extends contact tip life and protects internal components from damage. Trigger reset permits quick reset at torch rather than unit.
Standard built-in solid-state contactor circuit makes wire electrically "cold" until trigger is pulled. Makes unit safer, and is easier to position torch to work before starting weld.
Easy access to output studs provides convenient polarity changeover when switching from solid or flux cored wires.
Self-resetting motor protection circuit eliminates the need to find and replace fuses.
Uses 4 or 8 in (102 or 203 mm) spools and can be set up to weld with wire sizes .024-.035 in (0.6-0.9 mm) mild/stainless steel and .030-.045 in (0.8-1.2 mm) flux cored.
Add the Spoolmate 3035 spool gun and SGA spool gun adapter for welding with .030-.035 in (0.8-0.9 mm) aluminum wire on 14 gauge to 1/4 in material.
Specifications
Input Power
- Requires 1-Phase Power
- 230 V, 21.7 A, 60 Hz
Rated Output
- 135 A at 22.5 VDC, 30% Duty Cycle
Welding Amperage Range
Wire Speed
- 90 - 700 IPM (2.3 - 17.8 m/min)
Net Weight
Comes Complete With
- 10 ft (3 m) M-10 Miller MIG gun
- 10 ft (3 m) work cable with clamp
- Factory-installed gas solenoid valve
- Smith Argon and AR/CO2 mix regulator/flow gauge and gas hose
- 6 ft (1.8 m) power cord and plug
- Two contact tips for .024 in (0.6 mm) wire and two contact tips for .030 in (0.8 mm) wire
- Dual groove quick-change drive roll for .024 in (0.6 mm) or .030/.035 in (0.8/0.9 mm) wire
- Spool of Hobart .030 in (0.8 mm) solid wire
- Information/settings chart
- Set-up and operation video
Track up to 10 items on this computer in 
)
