P.A.T.T.I. Jr. Adhesion tester with F-1 piston

This Discontinued PATTI JR Package includes everything pictured above:

Analog Laboratory/Field control module

One F-1 Piston

High and Low pressure hoses

Instruction Manual

One Year Warranty

You may want to consider purchasing an Expendables Kit or PIPS Kit. Also, please note that this model does not allow for the use of self-contained CO2 cartridges! It must be charged with air from an air cylinder or via shop air. Alternatively, you may wish to consider the P.A.T.T.I. Pump

More about the P.A.T.T.I. System:

"The most accurate adhesion tester on the market!"

PATTI® APPLICATIONS:

The self-aligning PATTI® quantitatively measures the adhesion strength of numnerous coatings, including: paints, polymers, ceramics, inks, films, adhesives, and thermal or arc-sprayed metals.

Laboratory or field use (with proper accessories).

The test surface can be smooth, rough, porous, flat or curved (please contact us for application specific solutions). Custom-machined pull-stubs are available at any size, either flat or with a radius to match curved surfaces.

The PATTI® can also be used to test the strength of adhesives under non-room environmental conditions from 32-212 degrees Fahrenheit (0-100 degrees Celsius).

EASY TO USE:

The PATTI® uses compressed inert gas to apply a continuous tensile load to an aluminum pull-stub which is bonded to the test surface with an adhesive.

After the adhesive has cured, the operator attaches the selected piston. Then the operator pushes and holds the "RUN" button. A continuous load is then applied perpendicular to the pull-stub until failure occurs, or until a specified load is reached.

In the laboratory, nitrogen or any clean inert gas system providing at least 100 psig (up to 160 psig) can be used. SELF-ALIGNING, NO OPERATOR BIAS: The PATTI® features a patented piston design which assures uniaxial alignment with the pull-stub axis for "true tensile testing":