• These multi-output access control power supply/chargers are specifically

designed for use with access control systems and accessories. These units

convert a 115VAC / 60Hz input into five (5) individually protected

Class 2 Rated power limited 12VDC or 24VDC outputs (see specifications).

Each output will route power to a variety of access control hardware devices

including Mag Locks, Electric Strikes, Magnetic Door Holders, etc.

These outputs will operate in both Fail-Safe and Fail-Secure modes.

Controlled trigger input is achieved through normally open (N.O.) or

normally closed (N.C.) supervised input or the polarity reversal from an

FACP (Fire Alarm Control Panel). A form “C” dry output relay enables

HVAC Shutdown, Elevator Recall or may be used to trigger auxiliary devices.

• 12VDC or 24VDC selectable output.

• 6 amp supply current.

• Five (5) individual Class 2 Rated power

limited outputs rated @ 2.5 amp.

• Current limit is 12VDC or 24VDC @ 2 amp

per output.

• Input 115VAC / 60Hz, 1.45 amp.

• Input fuse rated @ 3.5 amp/250V.

• Fire Alarm Panel or Access Control System trigger

inputs. N.O. or N.C. supervised trigger input and

polarity reversal trigger input.

• Output relay energizes when unit is triggered

(form “C” contact rated 1 amp @ 28VDC).

• Power fail supervision relay (form “C” contact rated

1 amp @ 28VDC).

• Filtered and electronically regulated output.

• Short circuit and thermal overload protection.

• Built-in charger for sealed lead acid

or gel type batteries.

• Maximum charge current .7 amp.

• Automatic switch over to stand-by battery when

AC fails (zero voltage drop).

• AC fail supervision (form "C" contacts).

• Low battery supervision (form "C" contacts).

• Battery presence supervision (form “C” contacts).

• AC input and DC output LED indicators

(power supply board).

• Red LEDs indicate condition of power outputs

(multi-output board).

• Power & input trigger LEDs (multi-output board).

• Enclosure:

- Combination knockouts re 1/2” and 3/4”

- Accommodates up to two (2) 12VDC/7AH

batteries.

• Product weight:

- AL600ULM: 8.0 lbs.

- AL600ULMR: 8.4 lbs.

• Shipping weight:

- AL600ULM: 8.9 lbs.

- AL600ULMR: 9.3 lbs.

Rev. DSAL600ULM - L05F

UL Listed for Access Control Systems Units

(UL 294).

UL Listed Standard for Safety for Fire

Protective Signaling Systems (UL 1481).

CUL Listed - CSA Standard C22.2

No.205-M1983 Signal Equipment.

MEA - NYC Department of

Buildings Approved.

CSFM - California State Fire

Marshal Approved.

• Grey enclosure.

• Red enclosure.

123mm

279mm

318mm

130mm

83mm

130mm

30mm

36mm

19mm

36mm

167mm

83mm

25mm

25mm

24mm

83mm

83mm

19mm

24mm

123mm 36mm

31mm

36mm

130mm

30mm

25mm 267mm

25mm

330mm

13.5"H x 13"W x 3.25"D

Batteries not included!!!!