RC Airplane E-Flite eflite 25-Amp 25 amp Brushless ESC

Item Is:  E-Flite 25-Amp Pro Brushless ESC (Electronic Speed Control)

Part No.  EFLA1025

This was used in a 30oz RC Park Flyer Airplane with a 1800mah 3-Cell Lipo

Works great, I cut off the battery lead so you will have to solder one of your choice on. 

Here are the specs:

25-Amp Pro Brushless ESC

Key Features

• Up to 25-amp continuous current with proper air flow
• Finned heat sinks for both the motor drive MOSFETs and dual BEC regulators to support up to 4 sub-micro servos
• Programmable motor braking
• Safe power-arm mode prevents accidental starts
• Programmable low-voltage cutoff with settings for 2-cell Li-Po (6V), 3-cell Li-Po (9V) or 70% of battery starting voltage
• Programmable throttle input range (1.1–1.9 ms or Auto Select)
• Auto motor shut down if signal is lost or there is interference
• Programmable timing—2 user-selectable ranges for use with a large variety of brushless motors
• Pre-wired connectors—E-flite EC3 on battery input and 3.5mm female gold bullets on motor output leads
• Soft start

Overview

This controller has been designed for use in radio control aircraft and to support continuous currents of up to 25 amps when using 2- to 3-cell Li-Po battery packs and up to 4 sub-micro servos. The ESC features a lightweight plastic case with exposed, finned heat sinks for both the motor drive MOSFETs and, unlike many controllers, the BEC regulators give you a more reliable and powerful power supply for your servos.

Specs

• Brake:Yes - Programmable
• Continuous Maximum Current:25A
• Input Connector Types:16AWG with E-flite EC3 connector
• Output Connector Types:16AWG with 3.5mm Female Gold Bullet Connectors
• Momentary Peak Current:30A (15 sec)
• Dimensions (WxLxH):28x48x11 mm (1.1x1.9x.4 in)
• Weight:32 g (1.2 oz)
• Cells w/BEC:2-3S Li-Po or 6-10 Ni-MH/Ni-Cd