|
Step by Step Instructions!!! (images for instruction only, you will only recieve the item(s) listed in the title!
This is what a freshly cut sticker looks like! I decided to make a turtle, and put it on my Fastest Computer's case, however nearly any flat smooth surface can be used, including walls, glass, plastic, etc!
This is what the sticker looks like when it arrives at your home! There is a piece of transfer tape over the sticker, and a backing piece.

Peel off one side of the transfer tape, starting on the back side

Continue till one whole side is un-taped!

Turn the sticke over, and carefully peel the transfer tape off of the backing.

The sticker should be completely free of the backing on one side!

Remove the other side of the backing !

CLEAN YOUR SURFACE!
Make sure it is completely dry before proceeding! (Wet transfer methods exist, look into them if you prefer!)
Using the top corners of the transfer tape, line up where you want the sticker to go. Once it is lined up, carefully stretch the bottom corners down, to make sure the sticker is straight and tight!
Once the sticker is placed, use a squeege, or a credit card wrapped in a plastic bag to stick it down, and smooth it out, starting from the center, and working out!
Bubbles can be worked out by carefully pushing them off the edge of the sticker, using the squeegee.
Smoothe the entire sticker down.

Once it is in place, CAREFULLY pull back the transfer tape, at a steep ange, as shown in the above picture. Take special care around the finer details of the sticker, as you remove the transfer tape.

You are ready to Rock & Roll!!! |