|
AS SEEN IN SHOPNOTES® MAGAZINE!
ALSO SEEN IN FINE WOODWORKING®, WOODWORKER'S, WOODTURNER'S MAGAZINE, (UK), FARM SHOW®
$74.99
The Model #SS3 is able to hone chisels, plane blades and scraper-plane blades. Hone blades up to 1/4 inch thick and now up to 3 inches wide! Use the SS3 over stones up to 3/8 inches thick and up to 4 inches wide OR if using the Scary sharp technique, on a flat surface such as your table saw top, plate glass or granite surface plate with abrasive paper or pastes! Positive stop detents for setting your bevel angle from 5 to 60 degrees! Honing a "back-bevel" on your plane irons to increase the effective pitch angle for that tough, figured board, could not be easier using the NEW 5 or 10 degree positions! A NEW alignment slide helps ensure a square blade edge . $74.99
Our flagship product! Alisam's "Sharpening Sled™".
The easiest, fastest, most precise way to hand sharpen/hone your chisels, handplane and scraper plane blades*!
Made of sturdy anodized aluminum! *Depending on model
Four easy steps!
1) Loosen black handles and set your desired bevel angle using the precise, laser engraved index marks. Tighten handles.
2) Place the guide over your sharpening stone.
3) Insert blade, push alignment "slide" up against the side of the blade to ensure a square edge.
4) Tighten brass toggle foot clamp to secure blade and away you go!
The easiest to use sharpening/honing guide on the market!
*No measuring blade protrusion!
*No extra angle setup jigs to use!
-loosen locking knobs and select your angle
-angle set positively with mating detents
-primary OR micro bevel
*No unstable "unicycle" guides!
- 4 sealed radial bearings for rollers
-front bearings are spring loaded for a .010 inch "give"
-no rounding of blade corners
-no inaccurate blade angles
-Finally! Use the full length of stones!
-sharpen twice as fast
*Blade easily aligned perpendicular!
-not "by eye" but with a NEW alignment "slide"
-perfectly square blades
*Use with up to 4 inch wide stones, any length
(depending on model chosen).
Our satisfied customers respond!
"You have solved one of the final problems encountered with all preceding jigs, primarily, setting the angle with out any additional device or jig. From the Veritas to Richard Kell's jigs, your device has that final problem solved."
Boone, IA
"A brilliant design based on the traditional Japanese
method of plane blade sharpening."
Benton, PA
"I have to say that this is a real nice piece of engineering. It's a substantial piece with good ergonomics."
Philadelphia, PA
| |
Back to home page
) 
Alisam Engineering
Print
Report item
and your 