TRAXXAS EMAXX ALL ALUMINUM PROJECT TRUCK TONS OF HOPUPS

This is an all aluminum Traxxas E-Maxx project truck.  The truck is about half built, but I just don't have the time to work on it any more.  What is built of the truck has been tested and works, including the motors, speed control, receiver, servos, and gears.  This truck has been built up from nothing but a parts list and diagrams.  The only thing not aluminum is the transmission housing.  All of the gears are upgraded light weight aluminum, and both servos are metal-geared.  The chassis is built to hold 4 battery packs which will give you TONS of run time!  The truck is powered by two Trinity Monster Maxx Pro motors, each with a heatsink and cooling fan attached.  There's also a cooling fan mounted above the EVX speed control.  Both wide and narrow control arms are included, as well as wide and narrow CVD drive shafts.  I've been going with a mainly blue theme for the truck with just a bit of silver.  Here's a list of some of the hop-ups:

• Robinson Racing double disk slipper kit with extra pads
• Trackside RC Products blue aluminum screw set
• Titanium hinge pins
• Left, right, and center CVD's
• Dynamite aluminum chassis
• Robinson Racing steel diff. gears in both differentials
• Sway bar system
• Blue aluminum turnbuckles
• Ball bearings
• 3 channel receiver
• Proline steering kit
• RC Driven polished Ford bumpers
• 2 Hobbico metal-geared servos
• 2 motor heatsink/cooling fans
• RC Raven polished servo cover
• 2 Trinity Monster Maxx Pro motors
• 4 3300mAH battery packs
• EVX speed control
• Novak ESC cooling fan kit
• RC Driven polished skid plates
• Deans plugs
• Hard anodized pivot balls
• Integy control arms, bulkheads, chassis braces, steering blocks, diff cases
• Traxxas parts list and diagrams

There is over $1,000 invested in this truck, but my loss is your gain.  And all of the parts were brand new when installed, no used parts.  If you have any questions feel free to ask.  Good luck!!!

***USA bidders only please***