The HANDHELD BRASS Down Under Wonder Shower

Your Down Under Wonder Shower is shipped with a 2.5 GPM flow restriction device, a translucent white plastic disk with a tip on one side and a small diameter hole thru the center. To use flow restrictor insert disk into hex inlet nut of Wonder Shower with tip facing down or into the shower, not visible once inserted. Then insert one red/brown fibre washer on top of disk and attach as noted in installation instructions. 

Also, the Shower Head is an EXTRA WIDE 3.5"  with 127 Individual STREAMS of water rushing onto you!! 

Teflon tape is provided with your shipment to seal the shower pipe threads as the hex inlet is designed to seal with the fibre washer. (Similar to the way the rubber seal in a garden hose connection works)

This is the Heaviest Handheld Shower we have ever held.  Weighing in at almost 3 pounds it is sure to get your attention as The Wonder Shower is made completely of metal and no plastic pieces to worry about!   

Also, Your Handheld Wonder Shower comes with complete and easy instructions to ensure a NO HASSLE installation on your NEW Handheld Shower.....

If your anything like me, you probably have a few question you might like to ask yourself.  Here are a few frequent question received about the Wonder Shower..

Question- Will the Down Under Wonder work in any shower?

Answer- Yes The Wonder Shower has a standard 1/2" female pipe inlet so it can be installed on any standard shower fitting.

Question- Do I have to hire a plumber to install my Wonder Bathroom Shower?

Answer- You can install it yourself very easily because it's designed to be installed with very little actual plumbing work. The only time you need a wrench is to remove your old showerhead. The Wonder Shower comes with simple, easy to follow installation instructions.

Question- Can I install the Down Under Wonder Shower on the shower arm my old showerhead used to be?

Answer- Yes Simply remove old showerhead, clean threads on old arm and screw on your new Wonder Shower. Use lots of Teflon tape so the Wonder Shower will tighten easier, allowing it to tighten in place with the wing nuts in line with each other.

Question- If we prefer, how hard is it to replace the old shower arm along with the showerhead??

Answer-It's actually very easy. You simply unscrew the old arm from the female elbow behind the wall, tape the threads on both ends of a new 1/2" x 2" L brass male nipple and screw one end in where the old arm came out. Then attached your Wonder?Shower and you're done! 

Check out the warranty which comes with your NEW Wonder Shower:

The original purchaser(s) that this product will be free from defects in materials and workmanship for the lifetime of the product. 

This warranty is extensive in that it covers 100% replacement of any defective parts for life. However, damage due to installation error, product abuse, misuse, mineral deposit build up or use of abrasive cleansers, whether performed by contractor, service company or yourself, is excluded from this warranty. 

You will also have a FULL 30 Day no Questions asked Refund Policy..  If for any reason you are dissatisfied with your NEW Down Under Wonder Shower simply return it and you will be promptly refunded for your purchase!!

 Also Check out our Ebay Store for The Down Under Wonder Shower with an EXTRA Extension Arm for those who want double the length!! (This is great for Kids)

Thanks for Looking!!

Dennis Hughes