WINDOW APPLIQUE STICKER - BMW

CONTENTS:

• ONE APPLIQUE (8 X 8 INCH)
• ONE PAPER INSTALLATION INSTRUCTION (ALSO SHOWN BELOW)
• ONE ROUND-EDGED APPLIQUE APPLICATOR (1.75 X 3.5 INCH, FLEXIBLE PLASTIC)

INSTALLATION INSTRUCTIONS

Please read all instructions before installing.

1. Clean surface completely using a non-abrasive cleanser.  Most cleaners and products containing ammonia are NOT SAFE!  The best solution recommended is soap and water for this process.
2. Dry the surface.  Make sure that there is no remaining soap residue.
3. Spray fine mist of water on the surface.  This will allow you to reposition the graphic if needed.
4. Remove the opaque white backing (non-see through portion) from the application tape (see-through portion where you can see you applique).  Make sure that the sticker stays on the application tape.  If it starts to peel up with the application tape, then lower the tape down and squeegee tape to the applique.  Then pull up application tape and resume.
5. Carefully apply the sticker to the desired surface or place the sticker face up on a flat surface.  Position the window above the sticker for placement, then press the window down.  Flip the window over and remove the application tape.  NOTE:  It is best if you apply the top or bottom of the applique and squeegee up or down.  This has proven to bring the best results.
6. Using a squeegee, or a credit card, remove any air bubbles, working out from the center.  Remove as many as possible.
7. Remove the application tape from the sticker and discard the tape.
8. If you notice small air bubbles will be gone after a few days.  Do not poke holes to get rid of bubbles.  Poking holes is a last resort.

NOTE:  When poking holes, you may end up with a rough edge around the poked area.