Waterslide Inkjet paper media clear water decal vette

Inkjet Waterslide Decal Paper Specifications

To make CLEAR/TRANSPARENT decals:

The photo shows ready made decals. This auction is for 10 sheets of blank paper.

Detailed Instructions are included with the paper.

Print on the glossy side of the paper. In general selecting the transparency setting in your printer driver gives the best results. Our new Inkjet Aqua Slide decal paper works well with any "dye based ink" Inkjet printer.

Before sliding the decal off the paper using water you must seal the inkjet ink on the special coating by using clear spray or decal fixative.

If using Krylon spray then follow the instructions on the spray can.

If you are using the PAPILIO CLEAR Decal fixative. Then pour small amount over the image (the decal) and let it sit on the decal for about 10 seconds and gently move the puddle around, then wait few seconds. Without applying  pressure on the decal, use the foam pad (foam pads are included if you order the decal fixative from the manufacturer) to move the excess fluid off and over the edge of the paper onto a piece of cardboard and discard, leaving an even coating on the image. Let dry for few  hours or overnight. A second coat may not be needed at all. Using clear acrylic fixative or oil enamel may also give good results for most applications. For professional waterslide decal we however recommend the decal fixative sold by the manufacturer. It will last longer that acrylic spray and remains clear and flexible. To make permanent production decals you could use even stronger solution being the  liquid urethane (not to be confused with poly-urethane sold in hardware stores for wood finish)

Applying the decal.

Cut out the image with scissors. Dip in warm water (not hot). The paper will roll up and then straighten out again.

When the film starts to loosen from the paper, place the paper on the substrate to be decorated, and slide the paper from under the decal.

Work out air bubbles with decal squeegee and let dry. It is important to remove all water and air.

DO NOT cut out the decal first and then apply the solution as the edges of the paper will absorb the liquid, making it impossible later to slide the decal off the paper.

Shipping & Handling

 

Flat Rate

In USA by Priority mail
Flat rate $4.65

We accept PayPal for eBay sales

HYAZ, and PAPILIO are trademarks of  HPS  LLC  Newark / Rhome TX USA.