| 1971 Dodge Challenger Pro Street Drag car
|
|
Vehicle Description
|
|
Hello, I have a 1971 Challenger street / strip project that my friend and I started and never found the time to finish. The car has a full roll cage, This car was NHRA cert.( was certified to 7.50 before the rule change ) but was never raced. Chassis engineering ladder bar, coil over rear, Dana 60 rear end with 40 spline Moser axles and Richmond spool with 4.56 PRO gears. It has a set of weld Drag Stars 15x12 with ET streets 30x13.50x15 on the rear / tires are old and prob not usable. The car is partially back halved, Stock rear frame rails to the top then 2x3 straight back, Steel tubs, I was going to put the full interior back in this car. The cage fits nicely, neat and tucked up in the drivers compartment, you can hardly see it from the side view. The top was cut off to install the cage ,as to allow the best fit then welded back on. The car has a light coat of primer on it, New quarters were installed, body work needs to be finished. I have a stock flat hood, the front fenders have a been repaired, some rust on the inner sides,, there is a dash in the car( no cluster ) , it was notched for the roll cage. I was going to cover it with the replacement cover. Stock front suspension. I just don’t have the time to finish myself,. I also have a set of coil over for the front, not a direct bolt in but could be installed easily. If you need any more info, just ask. I do have the title and vin plate for this car. NOTE: this car does not have the 1971 tail light panel and grill. It does have a 1974 tail light panel installed along with the tail lights, and comes with a 74 grill assembly. I have some misc interior pieces, door panels, kick panels, etc.
|
|
|
| Please wait Image not available | | |
|
| |
| | Questions and answers about this item | | | | | | | | Q: Do you have the rest of rear end gears and the posi unit. A: I have the complete gear set. Ring and Pinion, Strange 40 spline full spool.
| Nov 05, 2009 | | | | Q: Hey, how cut up is the roof job and do you have any more pictures close up? Any glass for this project? I'm sure you planned on lexan or something but was wondering if you still had the stock glass.
Thanks,
S A: The roof was cut at/near the original weld line on the quarter and mid way on the front post. It is not hacked up. It needs to finish welded on the inside,that's it. There is a small layer of filler over the weld area,... Continue reading
| Nov 05, 2009 | |
| |
| Safe Buying Tips for Vehicles NEVER pay for a vehicle by instant cash transfer, such as Western Union or Moneygram. ALWAYS check the My Messages section in your My eBay page to confirm any emails from us requesting account information. GET up to $50,000 in Vehicle Purchase Protection FREE when you buy qualified vehicles on eBay Motors. BEWARE of fraudsters who send fake email messages claiming to represent or offer escrow services as part of eBay's Vehicle Purchase Protection program. | |
|