This cylinder is past 1st over bore because of wear, and should either be bored to 2nd over or sleeved back to standard. Note that this cylinder has the early shape base and is what came on an R67, R67/2 and very early R60. It will not work on a later R60/2 unless you don't mind running a total loss oil system. Bore Tech in Batavia, Ohio can do all the needed work on this cylinder, including carbide treatment and finish painting. I use their services for all my cylinder work. (I get no perks for mentioning them). Cylinder in photos is what will be shipped Packing and shipping: I will combine shipping where it applies. I will ship at cost via USPS or UPS if requested. Overseas shipping fee to be determined after end of auction. US and overseas bidders please wait for an invoice before paying. Pay Pal only, please. No returns.