Material :
Chrome steel , triple plated Copper /
Nickel / Chrome, With
Phenolic Plastic Emblem.
Neck Size :
5 1/8" most four barrels, two barrel
adapters are available in the air cleaner accessories
category
Emblems :
approximately 1/8" thick and are red and
chrome ,heat and fuel resistant .The are adhered with a
thermal adhesive then baked @ 260 degrees to set the
emblem in place and cannot be removed without damaging
them
Stud
and wing nut :
A new stud and
standard wing nut will be taped to the inside of your air
cleaner when you receive it. If you would like a fancy
wing nut for your air cleaner checkout MCC1048 ,
MCC1039 or MCC1059
Recessed Base
:
This air cleaner comes with a recessed base . It has a
total height of 3" from the carb flange( not including
wing nut). It will fit most Holley carburetors and was
designed for Holley double pumper carbs . If you are
running an Edelbrock carburetor you will need to use
MCC150c 1/2" riser to cleaner the fuel line and/or choke
housing.
Application :
Generally all cubic inch Ford
engines, Big Or Small Block engines
Installation tips :
Be sure to install the stud
into your carburetor and check your hood clearance to the
stud before closing the hood to avoid damaging your hood
.If necessary cut the stud to the correct height and
reinstall
Comments :
If you would like the
matching valve covers and air cleaner combo for a 429/460 use part number MCC62377
if you would like the
matching valve covers and air cleaner
combo for a 352-428 F. E. engine use part number
MCC62378
if you would like the
matching valve covers and air cleaner
combo
for a Midland or Cleveland engine use part number
MCC62379
if you would like the
matching valve covers and air cleaner
combo
for a
Small Block 260-351w engine use part number
MCC623
Back to home page
) 
MOTORCHROME.COM
Print
Report item
