Material :
Chrome steel , triple plated Copper /
Nickel / Chrome,
With Phenolic Plastic
Emblems.
Emblems : approximately
1/8" thick and are ,heat and fuel resistant .They are
adhered with a thermal adhesive then baked @ 260 degrees to
set the emblem in place and cannot be removed without damaging
them
Thickness : These valve
covers are stamped from approximately .040 thick steel.
Application :
Small Block Ford 351 Windsor engines
Restrictions
: Will not
work on later model 5.0L engines with fuel injection
Valve Covers : This set
is factory height (approximately 3 1/2" tall) . Each valve
cover has one hole in it for accessories. They CANNOT
be run with aftermarket roller rockers
Baffled :
YES, these
valve covers come with steel baffles in each
Gaskets :
NO, these do
not come with gaskets, Any
Quality gasket made for the small block Ford will
work on these valve covers
Valve Cover Accessories :
Hold downs, breathers, PCV valves
etc. DO NOT come with the valve covers but can be located
on the left side links on this page and purchased
separately . Each valve cover has 6 mounting holes so you
will need 12, bolts or spreaders etc. when ordering for
this set
Installation tips :
When
tightening your valve cover start on the low side and
tighten in a cross pattern to the correct torque spec . Do
not over tighten the valve covers when installing them!
Comments :
If you
would like this as a combo kit meaning valve cover and a
14 inch air cleaner use MCC43345
If you would like plain chrome
valve covers without emblems use part number MCC115
All
MotorChrome part numbers can be pulled up by typing the
MCC# into the search box