Material : Cast Polished Ball Milled Aluminum on both valve cover and air cleaner
,
Neck Size : 5 1/8" fits most four barrels, two barrel adapters are available in the air cleaner accessories category
Stud : Comes with 1/4 x 20 taped flush mount air cleaner stud
Base : This air cleaners base has a 1/2 inch extension the total height of the air cleaner from the carb is 3 inches including the stud.
Air Filter : 12 x 2 paper element, so when you need to replace we carry replacement filters MCC6020E, if you would like to add a K&N filter to your order it is MCC3505
Application : Small Block Chevy 327, 350 , 383 , 400 engines
Installation tips : Be sure to install the stud into your carburetor and check your hood clearance to the air cleaner before closing the hood to avoid damaging your hood .
Valve Covers : This set is factory height (approximately 3 1/2" tall) They will NOT clear factory air conditioning brackets. Each valve cover has one hole in it for accessories. They CAN be run with most aftermarket roller rockers
Baffled : YES, these valve covers come with steel baffles for each
Gaskets : NO, these do not come with gaskets, Any Quality gasket made for the Small Block Chevy will work on these valve covers
Valve Cover Accessories : Hold downs, breathers, PCV valves etc. DO NOT come with the valve covers but can be located on the left side links on this page and purchased separately . Each valve cover has 4 mounting holes so you will need 8, bolts or spreaders etc. when ordering for this set
Installation tips : When tightening your valve cover start on the low side and tighten in a cross pattern to the correct torque spec . Do not over tighten the valve covers when installing them!
Comments :
If you would like Just the valve covers use MCC6030
If you would like Just the air cleaner use MCC6020