1. The top layer is called the Application (transfer) Tape
2. The middle layer is the final product.
3. The bottom layer is called the backing (waxed) paper

PREPARATION:

• Thoroughly clean the surface. The surface you are applying the sticker to, must be clean, dry & free of any dust or residue.
• Ideally, the surface and air temperature should be 10?-20?C. DO NOT apply if the surface is overheated (black car exposed to sun for a long time) or in cold weather.
• After preparing surface, check that the sticker fits in place. If necessary, make guidelines with masking tape or a non-permanent marker.

 APPLICATION:

• Carefully remove the BACKING paper from the sticker. Ensure that no part of the design remains on it. Best practice - lie it face down and slowly peel the backing paper at a 180 degree angle.
• Position one edge of the sticker onto the prepared surface.
• Slowly roll the sticker onto the surface, rubbing it down with your thumb as you go.
• Using a credit card or something similar from the middle to the outer edges.
• Slowly remove application tape, ensuring that the sticker does not lift with the tape. I recommend that you leave the application tape on for 10 to 20 minutes before removing; this will ensure that the decal will adhere to the surface fully.
• Air bubbles - If any will usually disappear after a few weeks, if not, you use a pin to puncture the vinyl and squeeze the air by pushing down with your thumb.