Rear Alert™ Brake Light Safety Module

Alert Those Behind You When Slowing Or Stopping In Traffic!!!

This May Be The Most Important Safety Device You Ever Add To Your Ride!!!

It May Prevent You From Being Rear-Ended & It May Even Save Your Life!

You Need All The Rear End Protection You Can Get!

 You can Buy It Now for Only $14.95

Immediate Shipment - No Waiting!

Money Back Guarantee!

Fact Is You Won’t Find A Better Brake Light Module Anywhere At Any Price! 

Check our great feedback comments from our pleased customers...

 

Universal Hookup- One Module Fits All 12 Volt Brands/Models

This module converts your normal steady burning brake light into an attention getting flashing/blinking brake light to increase your visibility while braking.

Motorcycle drivers license manuals in 48 states specifically recommend that you flash your brake lights when slowing or stopping to help prevent rear-end collisions.  Need we say more... Do it automatically...

Here’s how it works: Each time the brakes are applied, your center high mounted brake light will rapidly flash On & Off for 3-seconds (5-6 flashes) and then burn steady until you release the brake.

If desired, the module can be reprogrammed for an additional 3-seconds of flashing. (approx 10-12 Flashes total)  Reprogramming is done by cutting the small green wire loop.

The preprogrammed cycle will start over and repeat each time the brakes are reapplied. The programmed cycle terminates immediately when the brakes are released.

Module operation is totally silent. There are no relay clicking sounds. There are no reset delays required for proper operation. It does not interfere with the turn signals or other vehicle circuits. No load resistor is ever needed for LED lights.

The small "waterproof" module is approximately 3/4"H x 1"W x 1 5/8"L and works with all types of brake lights including LED clusters. Heavy-Duty 10-Amp design for 12V Cars, Trucks, Motorcycles & Motor Homes.

Hook-up is very simple. Connections are made inline between the brake light switch and the brake light to be flashed.

(1) Cut vehicles brake light switch wire,  (2) Connect our red wire to the cut wire that comes from the brake switch,  (3) Connect our white wire to the cut wire that goes to the light bulb,  (4) Install the included red tap connector to light bulb’s ground wire,  (5) Insert our black wire into tap connector and crimp with pliers.

Manufactured by a Certified QS-9000 Factory and includes a No Risk Guarantee. If you are not 100% satisfied, simply return it for a full refund of your purchase price.

You Won’t Find A Better Brake Light Module Anywhere At Any Price! Guaranteed…

This Is A Quality Product With Performance & Features That’s Second To None!

New in Factory Sealed Plastic with Instructions

Thank You For Looking

Don't forget your friends, get one for them

Shipping Discount- Save $2.00 S&H on each additional unit

After purchasing, pay instantly with your credit card through PayPal!