Futaba S9252 Digital Servo Coreless All Purpose F3C

Includes:

• One (1) S9252 Digital Ball Bearing Servo with preinstalled round servo horn

• Four (4) each: eyelets, black rectangle rubber grommets, servo mount screws

• Three (3) additional Horns: 6-arm, large 4-arm, large round.

This is the Futaba S9252 Digital High Torque, All-Purpose F3C Servo with High-Current Wire Lead and "J" Connector

Features:

• Digitally enhanced microprocessors cut about half the response time from transmitter input to servo reaction.
• Coreless motor
• Dual ball bearings on the output shaft
• Plastic/nylon gear train
• Moderately high speed
• High current, high capacity wire lead with low resistance
• Case is made of Black plastic
• Dust and water resistant (Not waterproof)
• Works well with all control surfaces on F3C helicopters or precision fixed wing aircraft.
• One year warranty

Specifications:

• Speed: .14 sec/60° (based on 4.8V rating)

• Torque: 92 oz-in (6.6 kg-cm) (based on 4.8V rating)

• Weight: 1.8oz (50g)

• Power Supply: 4.8V. Futaba does not recommend using 6V

• Length: 1.6" (41mm)

• Width: .8" (20mm)

• Height: 1.5" (38mm)

COMMENTS: S9252 Digital Servo Precautions:

• It is best to avoid long leads and Y-harnesses especially with standard grade wires. If problems are encountered, consider using heavy duty wire such as Futaba's Heavy Duty Series or Hobbico's Pro Series ,minimizing lead lengths, and/or removing Y-harnesses.

• Current Drain: Futaba S9252 Servo is specially designed for high-torque and high-speed, therefore very high current drain is normal at startup. For ultimate performance when using this servo, please review the following points.

  • (1) Always use a 4.8V NiCd battery. Dry cells are rated at 1.5V each making the overall voltage 6V which will damage the gyro.

  • (2) When using systems with the battery fail safe function it has a higher cut-off voltage setting which will cause shorter operation time.

  • (3) When installing the servo please check pushrod linkage to make sure there is no binding in order to prevent excessive power consumption and decrease the life of the motor and battery.

• When Used With GY501 Gyro:

  • Switch the GY501 servo frame rate function (Frm) from "NOR" to "High" to display the performance of the gyro to the fullest.

  • Setting Method:

    • (1) Press the GY501 FUNC+ or - key to call the Servo Frame Rate Setup Screen.

    • (2) Press the DATA+ or - key to display "High".