mini Wireless Shutter Release Canon 1D 1Ds Mark II III

This wireless shutter release has strong anti-interference function and has 16 channels for you to choose. It is extremely useful if there are several photographers working nearby. Each photographer could choose their own channel to trigger off the shutter release of the camera they are going to use without triggering others’ because of overlapping signals. You also can control more cameras with the channel switches on the transmitter and the receiver, and extra receivers if you need.

Features:
Raeceiver attached to the camera's hot shoe when Radio triggering with the Transmitter for operations.

Available to use the Receiver as a remote cable release without the Transmitter.
Also works without the Battery when using the Receiver as a remote cable

Wirelessly Trigger Your Camera's Shutter
-With the receiver connected to your camera's remote control socket, you can press the button on the remote control to trigger your camera's shutter wireless !

Two-Level Shutter Button, Autofocus, Continuous Drive & Bulb Mode Supported Too!
-The shutter button can be pressed halfway or all the way.
-You can activate autofocus, release shutter, activate continuous drive mode or keep the shutter open for bulb photography as well.

Important functions  Bulb Shutter(B.Shutter):
this SM-  Kit supports the Bulb shutter. To use Bulb shutter function, press the shutter button on the Transmitter for 4 sec. until the Red LED on the Transmitter is automatically off. You can see the Red LED on the Receiver is continuously ON during the performance. To release the Bulb Shutter, press the shutter button on the Transmitter shortly.

Dimensions: 
Transmitter (L x W x D):
82mm x 26mm x 15mm;
Receiver (L x W x D):
52mm x 39mm x 29mm;

16 Channels with Working Distance of 50 Meters!
-Strong resistance to interference.
-There are 16 channels available so that you can switch to other channels to avoid jamming frequency.
-Maximum working distance is about 50 Meters in open area without blockage.

Energy Saving Design, Long Working Hour
-With its low voltage and energy saving design, you don't have to change the battery often.
-With a new battery, the receiver standby time is about 1000 hours.
-With a new battery, the remote control can trigger about 20,000 times.

How to Connect?
1. Switch off the camera.
2. Make sure the receiver and remote control are on the same channel (check the little switch on them).
3. Connect the receiver to your camera's remote control socket.
4. Press the button on the receiver to turn it on.

• Transmitter x1
• Receiver x1
• CR2 Battery (installed in receiver) x1
• 23A Battery (installed in remote control) x1
• English Instruction Manual