RS TECHNOLOGIES 910 PORTABLE PEAK METER

The Model 910 is a single-channel, portable transducer indicator. It has the following features:

• Five peak memories to store and recall the peak or maximum torque or force on five cycles
• Track mode to view the transducer output continuously and during calibration
• Manual span adjustment allows the peak or track readings to be in direct engineering units
• Manual zero adjustment
• Nickel-cadmium rechargeable battery offers eight hours continuous operation before requiring a charge
• Accommodates industry standard transducers with outputs of between 0.8 and 5.0 mV/V
• Calibrates using external shunt calibration resistor
• CW/CCW reversing switch
• Three selectable decimal point positions
• Analog output receptacle for use with chart recorders

Typical Applications

The Model 910 is a versatile measurement tool designed for use on several different applications involving physical measurement: torque, tension, compression, force, strain, and pressure. Below are some typical applications for which the Model 910 can be used in the field.

Model 910 Specifications
Instrument Accuracy	±0.5% FS
Non-linearity	±0.25% FS
Temperature Range	0 to 60°C
Battery	8 hour life
Recharger	120 vac, 8-14 hour for complete recharge
Input Sensitivity	350 to 1000 Ohm, full bridge
Input Signal	0.8 to 5.0 mv/v
Display	0.6-inch high LED, 3½-digits, 1999 maximum display
Operating Modes	Peak, Track
Bridge Excitation	10 vdc
Frequency Response	DC to 3.2 kHz
Peak Memory Drift	Less than 1.0% FS in 15 minutes
Calibration	Binding posts for external resistors
Output Jack	0 to 1 volt dc nominal output
Dimensions	9.50" high, 4.20" wide, x 2.75" deep
Weight	1.4 lbs.