A reserve price is the minimum price the seller will accept. This price is hidden from bidders. To win, a bidder must have the highest bid and have met or exceeded the reserve price.
BOOT INFO:
U-Boot 1.3.3(2) (Jul 9 2008 - 01:41:09)
Type ? for a list
I
CPU: 8548_E, Version: 2.0, (0x80390020)
Invalid input -> o
Core: E500, Version: 2.0, (0x80210020).0.0
Clock Configuration:
Type ? for a
CPU:1000 MHz, CCB: 400 MHz, -> ospf passive, ip ospf passive
DDR: 200 MHz (400 MT/s data rate), LBC: 50 MHzr a list
Error - invalid virtual ethe
L1: D-cache 32 kB enab
L2 cache 512KB: enabled
NAND: 256 MiB201 255.255.25
*** Warning - bad CRC, using default environmente ? for a list
Incomplete comma
In: serialde
Out: serial
Inva
Err: serialspf area 10.2
Net: eTSEC0, eTSEC1, eTSEC2, eTSEC3 [PRIME]
POST: i2c fpga fpgaint nor nand picint rtc [F] uart ethernet switchip ospf passive
Type ?
Hit any key to stop autoboot: 0r - invalid virtual ethernet int
### JFFS2 loading 'slot1/vmlinux.ub' to 0x1000000
Invalid input -> address 10.251.7.
Scanning JFFS2 FS: . done.
Type ? for
Created: 2008-07-11 20:43:05 UTCd, ip nat inside
Image Type: PowerPC Linux Multi-File Image (gzip compressed)r-address 1 10.251.254.
Data Size: 1387504 Bytes = 1.3 MB
Type ? for a list
In
Load Address: 000000000.251.0.0, ip ospf area 1
Entry Point: 00000000
Contents:
Type
Image 0: 1360375 Bytes = 1.3 MBinput -> ospf passive, ip ospf passive
Image 1: 27116 Bytes = 26.5 kB
Type ? for a list
Verifying Checksum ... OK filter-group in 64 , ip rip
Uncompressing Multi-File Image ... OK
In
teak_setup_archutside, ip nat
Built 1 zonelists
Kernel command line: rw=/dev/mtdblock3 console=ttyS0,115200lid virtual ethernet interface number.
OpenPIC Version 1.2 (1 CPUs and 60 IRQ sources) at fdfbd0001.251.254 255.255.252.0, ip address 10.251.251.254
PID hash table entries: 4096 (order: 12,
51.251.201 255.255.252.0 s
Memory: 516608k available (2192k kernel code, 640k data, 112k init, 0k highmem)valid input -> ospf area 10.251.0.0, ip ospf area 10.251.0.0
Mount-cache hash table entries: 512
Type ? for a list
checking if image is initramfs...it isn't (no cpio magic); looks like an initrd
Type ? for a list
SW: Version 09.4.00h
Freeing initrd memory: 26k freedry Networks, Inc.
NET: Registered protocol family 16
Compi
Generic PHY: Registered new driverled as WXR09400h
NET: Registered protocol family 2
HW: ServerIronGT E-2
IP route cache hash table entries: 16384 (order: 4, 65536
JFFS2 version 2.2. (NAND) (SUMMARY) (C) 2001-2003 Red Hat, Inc.
SL 2: B
fuse init (API version 7.6)odule, SYSIF 2 (Mini GBIC)
Registering unionfs 1.3
unionfs: debugging is not enabled
2048 KB BRAM,
Initializing Cryptographic API
io scheduler noop registeredK+0K) and 2048*8 CAM entries
io scheduler anticipatory registered (default)
serial8250.0: ttyS0 at MMIO 0xe0004500 (irq = 26) is a 16550A
=======================================
serial8250.0: ttyS1 at MMIO 0xe0004600 (irq = 26) is a 16550A
SL 3: B8G/BxG
RAMDISK driver initialized: 16 RAM disks of 131072K size 1024 blocksize
Serial #: ÿ
loop: loaded (max 8 devices)ion 1, BM version 21
Gianfar MII Bus: probed
512 KB PR
eth0: Gianfar Ethernet Controller Version 1.2, 00:1a:17:09:02:00
eth0: Running with NAPI enabled
eth2: Gianfar Ethernet Controller Version 1.2, 00:1a:17:09:02:02
===============================
eth2: Running with NAPI enabled===========
eth2: 1024/256 RX/TX BD ring size
SL 4: B24E C
eth3: Gianfar Ethernet Controller Version 1.2, 00:1a:17:09:02:03: Non-exist
2048 KB BRAM, SMC version
eth3: Running with NAPI enabled
2
eth3: 1024/256 RX/TX BD ring size entries for DMA 12, version 0808
Marvell 88E1101: Registered new driver
256
Micrel KS8721: Registered new driveres for DMA 1
phys_mapped_flash: Found 1 x16 devices at 0x0 in 16-bit bankam at 3fffffe0, mp_flash_size = 004ba687
Intel/Sharp Extended Query Table at 0x0031INFO: code decompression completed
Using buffer write method
BOOT INFO: branch to
cfi_cmdset_0001: Erase suspend on write enableding hardware......
R
cmdlinepart partition parsing not availableror - can't use Jetcore module with M5 mana
RedBoot partition parsing not available
Error -
rfd_ftl: no RFD magic found in 'phys_mapped_flash'(slot 2)
ftl_cs: FTL header
Error - module type at slot 2 is no
0x00000000-0x01000000 : "NAND Flash Partition 1 (boot)"
Error - can't use non-JetCore module in this chassis
ftl_cs: FTL header not found.
0x01000000-0x04c00000 : "NAND Flash Partition 2 (slot0)"
Error - c
ftl_cs: FTL header not found. this chassis (slot 4)
0x04c00000-0x08800000 : "NAND Flash Partition 3 (slot1)"ror - module type at slot 4 is not supported
ftl_cs: FTL header not found.
Invalid port 2/1
0x08800000-0x0c400000 : "NAND Flash Partition 4 (slrt 4/5
Invalid port 2
ds1307 1-0068: rtc intf: dev (254:0)ut -> client-interface, client-inter
ds1307 1-0068: rtc core: registered ds1307 as rtc0
Type ? for a list
Invalid po
Teak XFP Driver installedalid input -> client-inte
ip_tables: (C) 2000-2006 Netfilter Core Team
Type ? for a l
TCP bic registered
Error - invalid
NET: Registered protocol family 1
NET: Registered protocol family 17address 64.152.73.65 255.255.255.1
ds1307 1-0068: setting the system clock to 2000-05-08 01:23:07 (957748987)
55.255.255.128
Type ? for
RAMDISK: Compressed image found at block 0rtual ethernet interface
JFFS2 notice: (1) check_node_data: wrong data CRC in data node at 0x0129c800: rePC Linux Multi-File Image (gzip compressed)dry Networks, Inc.
ad 0x906fb60b, calculated 0x6e1ba82a.ize: 1388124 Bytes = 1.3 MB
JFFS2 notice: (1) check_node_data: wrong data CRC in data node at 0x031ec800: re
Entry Point: 00000000
Contents:
ad 0x8aa5da24, calculated 0x2ab13eb1.B
images/rootfs.img: OK2 Bytes = 26.5 kB
INIT: version 2.86
JFFS2 notice: (27) read_dnode: header CRC failed on node at 0x37e47ec: read 0xff-gcbf0bda0 (edchien@ash) (gcc version 4.1.2) #
ffffff, calculated 0xd148cafd
1 PREEMPT Fr
JFFS2 notice: (27) read_dnode: header CRC failed on node at 0x37f17c4: read 0xff
Built 1 zonelists
Kernel command line: rw=/dev/m
ffffff, calculated 0x4dc4ba97
Starting syslogd
Ope
0:03 not found
eth2: Could not attach to PHY
Mount-cache hash table entr
SIOCSIFFLAGS: No such device
NET: Registered protocol family 40
NET: Registered protocol family 45
NET: Registered protocol family 46
NET: Registered protocol family 41
Fujitsu Kernel Driver installed
device eth1 entered promiscuous mode
NET: Registered protocol family 43
File: /local/edchien/build.080709/teak-build/compile-R3000-ppcspe/zebos/bcn/kern
el/bcn.c, Line: 291
BCN module init started
File: /local/edchien/build.080709/teak-build/compile-R3000-ppcspe/zebos/bcn/kern
el/bcn.c, Line: 242
Kernel control thread init
File: /local/edchien/build.080709/teak-build/compile-R3000-ppcspe/zebos/bcn/kern
el/bcn.c, Line: 265
Registered character device
File: /local/edchien/build.080709/teak-build/compile-R3000-ppcspe/zebos/bcn/kern
el/bcn.c, Line: 299
BCN module init over
PowerPC Book-E Watchdog Timer Enabled (wdt_period=63)
Starting sshd
Starting telnetd
login:
Used Unit
SKU
CP-02
Warranty
Thirty Days
Payment
MoniComp Accepts:
VISA, MasterCard, American Express With Paypal only, Money
Order / Cashiers Checks, Company Checks and Personal check (Personal
Check, Company Check will be held 5 business days).
Shipping
Buyer pay fix amount shipping cost $60 in the 48 states.
Canada, Hawaii and Alaska pay the actual shipping cost.
Shipping by Fedex and UPS.
Term
Payment must received within 5 businness days after our
conformation was sent to all winning bidder. If the payment is not
recived with in 5 days, the order is cancelled and none payment
bidder will be file with Ebay. CA sales tax will be added to the
auction for all items shipping to California.
Returns are allowed within 10 busniness days from the date the
unit arrived for full refund or replacement. Refund full amount but
not include the shipping cost. Buyer pay the freight cost when
return the unit.
Back to home page
) 
Vtrades
