100 LEVEL LCD REMOTE CONTROL DOG SHOCK TRAINING COLLAR

Here comes a latest humane remote dog training system! With clear LCD monitor displaying levels of stimulation, vibration, it provides you the safe and humane dog training you always pursue. The collar is designed as intelligent engineering with internal antenna. Thanks to its rheostat dial allowing for gradual adjustment (100 levels) in stimulation intensity, you can find the best level for your dog’s temperament and the type of training you do.

With no jumps between 0 and 100 levels, consistent and correct use of this remote dog trainer allows you to reinforce commands and correct dog's mis-behaviour from up to 300 meters. Low power consumption the remote transmitter to send a signal, activating the collar receiver to deliver a harmless stimulation. Digital remote control use different identity codes to prevent conflicts with other e-collars.

 Features:

• Brand New
• LCD Monitor Display & Belt-clip designed remote
• 100 levels of vibration
• 100 levels of static shock
• With no jumps from 0 to 100 levels
• 300 meters remote controlling range
• Rheostat dial allows for gradual adjustment in stimulation intensity
• Four modes: static shock, vibration, beep and light
• Clear LCD screen displaying level of stimulation collar
• Over 3,000 different identity codes to prevent conflicts with other e-collars
• The levels can be altered by use of up and down button.
• A tone button activates a tone on the receiver.
• The system can be used for 1 or 2 receivers. (This package had included 1 receiver)
• The receiver will TURN OFF if it is unused for 4 minutes.
• Any movement will activate the receiver into STANDBY MODE.
• The transmitter will go into STANDBY MODE if there is no operation after 20 seconds and turn off after 2 minutes

• About Transmitter
  • To install the batteries, open the battery cover.
  • the battery cover is at the back of the transmitter.
  • Open by sliding the over down.
  • Install 2 x 4LR4/6V batteries (Included) - ensure the the polarity is correct.
  • The transmitter will be TURN ON automatically.
  • Press the buttons one by one: the LCD images will be changed.
  • Press the up and down buttons on right hand side to set level
  • Choose channel 1 or 2 for 1 or 2 receivers
  • The LED light can be used for giving training signals.
  • The transmitter will go into STANDBY MODE if not operated for 20 seconds and will TURN OFF if not operated for 2 minutes.
  • In STANDBY MODE, press any button (except LED light button) to wake it up.
  • To TURN ON the transmitter, hold mode button at least 5 seconds

• About Receiver and Matching with the Transmitter
  • Install the batteries
  • Remove the cover
  • Insert 2 x AAA/1.5V batteries (Not Included) ensure the polarity is correct.
  • The receiver will beep.
  • Go to the transmitter and choose Channel 1 or 2 to encode by pressing the channel button 1/2 in the transmitter.
  • Press the LAUNCH button on transmitter immediately.
  • The receiver will beep, by now, it has been encoded to the transmitter.
  • Replace cover and tighten metal probes.

  　

• How to Check the Static is Working
  • Use the test light LED - provided. Attach the light to the metal probes - select Static Mode - you can see static symbol on the screen - press the LAUNCH button - the LED will flash on.
  • Select a low number on the LCD display - put your fingers on the metal probes and press the launch button.  

Package included:

• 1 x Transmitter
• 1 x Receiver
• 1 x Belt
• 1 x Testing Bulb
• 2 x 4LR44 6V Battery
• 1 x User Manual